Ordinary DV300 paste tile adhesive

Product description

This product is ready to use and does not need any other additives.

Hints

• Note that by adding any other substance to it, it loses its adhesive properties.
• This product is used in indoor environments.
• This product is not suitable for wet environments.

Indications

This glue is suitable for use on cement, plaster, mosaic, stone, ceramic and tile surfaces.

Dosage:

Depends on the environmental conditions; however, in a normal condition about 3 to 4 kilograms are used per square meter.

instructions

Put a thick layer of 3 to 6 mm of the product on the back side of a tile or ceramic with a toothed spatula and then fix it on the surface by a turning movement. Before starting the work, clean the desired surface from any pollution, dust, surface decay and grease. In the case of plaster surfaces, the dead layer on the plaster and the paint layer on it must be shaved before starting the work. Then apply a layer of diluted concrete glue with a brush on the work surface and after it dries, apply some of the paste glue to the back of the tile with a toothed spatula (to create a groove for a better connection) and some to Apply the surface of the wall and then install the tile on the wall and increase the adhesion of the tile to the wall with uniform strokes.

Packaging and storage conditions

Expiration Date: 9 months after production

Storage: Keep in +10 to +40 C, away from heat, humidity and direct sunshine.